LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1994 >> Legacy Alpine >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 35 - Purge Control Solenoid Valve
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 35 - Purge Control Solenoid Valve

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Turn ignition on. Measure voltage between ECU connector F47, terminal No. 6 (backprobe) and ground. If 10-13 volts are present, check ECU terminals for poor contact or replace ECU. If 10-13 volts are not present, go to next step.
  2. Disconnect purge control solenoid valve connector. Measure resistance between solenoid valve terminals. If resistance is 36 ohms at 68°F (20°C), go to next step. If resistance is not 36 ohms at 68°F (20°C), replace purge control solenoid valve.
  3. Disconnect ECU and solenoid valve connectors. Measure resistance between ECU connector F47, terminal No. 6 and purge control solenoid valve connector terminal No. 2 (White/Blue wire). Zero ohms should be present. Measure resistance between solenoid valve connector terminal No. 2 (White/Blue wire) and ground. Minimum one megohm should be present.
  4. Disconnect, in order, negative and positive cables from battery. Measure resistance between solenoid valve connector terminal No. 1 (Yellow/Red wire) and battery positive terminal. Zero ohms should be present.
  5. If resistances are to specification, check ECU terminals for poor contact or replace ECU. If resistances are not to specification, repair harness or connector as necessary.
scientia non olet · About LEMON Manuals