LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1994 >> SVX LSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 51 - Neutral Position Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 51 - Neutral Position Signal

NOTE: Refer to illustration for ECU connector and terminal identification. See Figure .
  1. Turn ignition switch to ON position. Using a DVOM, check voltage between ECU connector B60, terminal No. 10 (backprobe) and ground. With shifter in Neutral, voltage should be zero.
  2. Check voltage at terminal No. 10 with shifter in all other positions. Voltage should be 8 volts or greater. If voltage is not as specified, go to next step. If voltage is as specified, check ECU connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECU.
  3. Turn ignition switch to OFF position. Disconnect neutral switch connector located near transaxle dipstick. Using an ohmmeter, check resistance between neutral switch connector terminal No. 1 (Light Green/Yellow wire) and ground. With shifter in Neutral, resistance should be zero ohms.
  4. Check resistance at terminal No. 1 with vehicle in all other shift positions. Resistance should be one megohm or greater. If resistances are not as specified, replace neutral switch. If resistances are as specified, repair circuit between ECU and neutral switch as necessary.
scientia non olet · About LEMON Manuals