LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1995 >> SVX LSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 31 - Throttle Position Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 31 - Throttle Position Sensor

NOTE: Refer to illustration for ECM connector terminal identification. See Figure .
  1. Turn ignition off. Disconnect throttle position sensor connector. Using an ohmmeter, check resistance between sensor terminals No. 1 (Red wire) and No. 3 (Black wire). Resistance should be 5000 ohms. Check resistance between sensor terminals No. 2 (White wire) and No. 3 (Black wire), while slowly opening throttle valve from closed position.
  2. Resistance should be 10,000-12,000 ohms at fully closed throttle and 3000-5000 ohms at fully open throttle. Resistance should increase in response to throttle valve opening. If resistance is as specified, go to next step. If resistance is not as specified, replace throttle position sensor.
  3. Disconnect ECM connectors. Using an ohmmeter, check resistance between ECM connector terminal B1 and sensor connector terminal No. 3 (Black wire), between ECM connector terminal B2 and sensor connector terminal No. 1 (Red wire), and between ECM connector terminal B3 and sensor connector terminal No. 2 (White wire). Resistance should be zero ohms.
  4. Check resistance between ground and connector terminals B1, B2 and B3. Resistance should be one megohm or greater at each terminal. If resistance is not as specified, repair appropriate circuit as necessary. If resistance is as specified, check ECM connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECM.
scientia non olet · About LEMON Manuals