LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1995 >> SVX LSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing >> Code 35 - Purge Control Solenoid Valve
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 35 - Purge Control Solenoid Valve

NOTE: Refer to illustration for ECM connector terminal identification. See Figure .
  1. Turn ignition on. Using a DVOM, check voltage between ECM connector terminal D14 (backprobe) and ground. Voltage should be 10 volts or greater. If voltage is not as specified, go to next step. If voltage is as specified, go to step 4).
  2. Turn ignition off. Disconnect ECM and main relay connectors. Using an ohmmeter, check resistance between ECM connector terminal D14 and main relay connector terminal No. 1 (Black/White wire). Resistance should be zero ohms. If resistance is as specified, go to next step. If resistance is not as specified, repair circuit as necessary.
  3. Turn ignition on. Using a DVOM, check voltage between ground and main relay connector terminals No. 1 (Black/White wire) and No. 2 (Brown/Black wire). Voltage should be 10 volts or greater at each terminal. If voltage is as specified, replace main relay. If voltage is not as specified, repair appropriate circuit as necessary.
  4. Turn ignition on. Using a DVOM, check voltage between ECM connector terminal D6 (backprobe) and ground. Voltage should be 7 volts or greater. If voltage is not as specified, go to next step. If voltage is as specified, check ECM connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECM.
  5. Turn ignition off. Remove collector and disconnect purge control solenoid valve connector. Using an ohmmeter, check resistance between ECM connector terminal D6 and solenoid valve connector terminal No. 2 (White/Red wire). Resistance should be zero ohms. If resistance is as specified, replace purge control solenoid valve. If resistance is not as specified, repair circuit as necessary.