Select Cable: Installation

WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install select cable to plate assembly.
Tightening torque:
1. 32 N.m (3.3 kgf-m, 24 ft-lb)
Install select cable to range select lever.
Install plate assembly to transmission.
Tightening torque:
1. T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
  
  Fig 1: Installing Plate Assembly
Install snap pin to range select lever.

Fig 2: Installing Snap Pin
Move the select lever to the "N" position, then adjust the select cable position. See ADJUSTMENT .
Install heat shield cover.

Fig 3: Installing Heat Shield Cover
Install rear exhaust pipe to muffler.
Install under cover.