MT Gear Shift Lever: Installation

WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the joint to the transmission and secure with the straight pin.
Insert gear shift lever from room side.
NOTE: After inserting rod and stay, temporarily put them onto transmission mount.

Fig 1: Inserting Gear Shift Lever
Mount cushion rubber on the body.
Tightening torque:
1. 18 N.m (1.8 kgf-m, 13.0 ft-lb)
  
  Fig 2: Mounting Cushion Rubber On The Body
Connect rod to the joint.
Tightening torque:
1. 18 N.m (1.8 kgf-m, 13.0 ft-lb)
  
  Fig 3: Connecting Rod To The Joint
Connect stay to transmission bracket.
Tightening torque:
1. 18 N.m (1.8 kgf-m, 13.0 ft-lb)
  
  Fig 4: Connecting Stay To Transmission Bracket
Install heat shield cover.

Fig 5: Installing Heat Shield Cover