Clear Memory
Current trouble codes shown on the display are cleared by turning the ignition switch OFF after conducting on-board diagnostics operation. Previous trouble codes, however, cannot be cleared since they are stored in the TCM memory which is operating on the back-up power supply. These trouble codes can be cleared by removing the specified fuse (located under the light or left lower position of the instrument panel).
CLEAR MEMORY:
Removal of No. 4 fuse (for at least one minute) .
- The No. 4 fuse is located in the line to the memory back-up power supply of the TCM. Removal of this fuse clears the previous trouble codes stored in the TCM memory.
- Be sure to remove the No. 4 fuse for at least the specified length of time. Otherwise, trouble codes may not be cleared.
DTC INDEX
| DTC | Description |
|---|---|
| DTC 11 | ENGINE SPEED SIGNAL |
| DTC 27 | ATF TEMPERATURE SENSOR |
| DTC 31 | THROTTLE POSITION SENSOR |
| DTC 33 | VEHICLE SPEED SENSOR 2 (FRONT) |
| DTC 36 | TORQUE CONVERTER TURBINE SPEED SENSOR |
| DTC 38 | TORQUE CONTROL SIGNAL |
| DTC 45 | INTAKE MANIFOLD PRESSURE SIGNAL |
| DTC 71 | SHIFT SOLENOID 1 |
| DTC 72 | SHIFT SOLENOID 2 |
| DTC 73 | LOW CLUTCH TIMING SOLENOID |
| DTC 74 | 2-4 BRAKE TIMING SOLENOID |
| DTC 75 | LINE PRESSURE DUTY SOLENOID |
| DTC 76 | 2-4 BRAKE DUTY SOLENOID |
| DTC 77 | LOCK-UP DUTY SOLENOID |
| DTC 79 | TRANSFER DUTY SOLENOID |
| DTC 93 | VEHICLE SPEED SENSOR 1 (REAR) |