LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control >> ABS Sequence Control >> Operation >> Abs Sequence Control With Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Sequence Control With Select Monitor

NOTE:
  • In the event of any trouble, the sequence control may not be operative. In such a case, activate the sequence control. See ABS SEQUENCE CONTROL  .
  • When the diagnosis terminal is connected to the diagnosis connector, the sequence control will not operate.
  1. Connect select monitor to data link connector beside driver's seat instrument panel lower cover.
  2. Turn ignition switch ON.
  3. Turn select monitor switch ON.
  4. Put select monitor to "BRAKE CONTROL" mode.
  5. When "Function check sequence" is selected, 'ABS sequence control' will start.
  6. The message 'Press Brake Pedal Firmly' is displayed as follows:
    1. When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lb).
    2. When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2 , 498 psi).
    CAUTION: Do not depress the clutch pedal.
  7. When the message "Press YES" is displayed, press YES key.
  8. Operation points will be displayed on select monitor.
scientia non olet · About LEMON Manuals