Customer Supplied Only One Valid Key
WARNING: This page does not describe the selected car, but rather 164 other vehicles, including the 2002 Volvo V70, 2002 Volvo V40, 2002 Volvo S80, 2002 Volvo S60, and 2002 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Cut new transponder equipped key(s), if necessary. After PCM has been replaced. Using new first key, turn ignition switch to ON position. SECURITY light should illuminate for 1-2 seconds. Turn new first key to LOCK position.
- Using valid key, turn ignition switch to ON position, then LOCK position 6 times. DO NOT leave key in either position for more than one second. Ensure sixth turning is done within one second. SECURITY light should be flashing at a 300-millisecond interval. Wait about 5 minutes until SECURITY light flashing has decreased to a 1.2-second interval.
- Input code word. See INPUTTING CODE WORD . SECURITY light should stop flashing and stay illuminated. Using valid key, turn ignition switch to ON position. SECURITY light should illuminate for 1-2 seconds. Turn valid key to LOCK position and remove key.
- Using new second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new second key to LOCK position and remove key.
- Repeat step 4 with each new key, up to 8 keys total. Wait 30 seconds, program will quit automatically. After reprogramming is complete, clear DTCs with New Generation Star (NGS) tester.