LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> Ignition Systems >> Crankshaft Position Sensor Resistance >> 3.0L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor Resistance: 3.0L

  1. Crankshaft position sensor is located on top rear of engine, in front of throttle body. Disconnect negative battery cable. Remove air cleaner. Remove engine wiring harness bracket from intake manifold. Remove crankshaft position sensor service hole cover.
  2. Remove bolt attaching crankshaft position sensor to cylinder block. Remove crankshaft position sensor and disconnect electrical harness connector. Using an ohmmeter, check resistance between electrical terminals on crankshaft position sensor. Crankshaft position sensor resistance should be 800-1300 ohms. If resistance is not as specified, replace crankshaft position sensor.
scientia non olet · About LEMON Manuals