Read Current Data

On the << Main Menu >> display screen, select the {Each System Check} and press the << YES >> key.
On the << System Selection Menu >> display screen, select the {Brake Control System} and press the << YES >> key.
Press the << YES >> key after displayed the information of ABS type.
On the << Brake Control Diagnosis >> display screen, select the {Current Data Display & Save} and press the << YES >> key.
On the << Data Display Menu >> display screen, select the {Data Display} and press the << YES >> key.
Using the scroll key, move the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.

ABS CONTROLS CURRENT DATA DISPLAY

Display screen	Contents to be monitored	Unit of measure
FR Wheel Speed	Wheel speed detected by the Front Right ABS sensor is displayed	km/h or MPH
FL Wheel Speed	Wheel speed detected by the Front Left ABS sensor is displayed	km/h or MPH
RR Wheel Speed	Wheel speed detected by the Rear Right ABS sensor is displayed	km/h or MPH
RL Wheel Speed	Wheel speed detected by the Rear Left ABS sensor is displayed	km/h or MPH
Stop Light Switch	Stop light switch signal	ON or OFF
Stop Light Switch	Stop light switch monitor voltage is displayed.	V
G sensor output Signal	Refers to vehicle acceleration detecting by the analog G sensor. It appears on the select monitor display in volts.	V
Valve Relay Signal	Valve Relay Signal	ON or OFF
Motor Relay Signal	Motor Relay Signal	ON or OFF
ABS Signal to TCM	Motor Relay Signal	ON or OFF
ABS Warning Lamp	ON operation of the ABS warning light is displayed.	ON or OFF
Motor Relay Monitor	Operating condition of the motor relay is displayed.	High or Low
Valve Relay Monitor	Operating condition of the valve relay is displayed.	ON or OFF
CCM Signal	ABS operation signal from ABS control module to TCM	ON or OFF

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.