G Sensor: Inspection

INSPECTION

No.	Step	Check	Yes	No
1	CHECK SUBARU SELECT MONITOR.	Do you have SUBARU SELECT MONITOR?	Go to step 5.	Go to step 2.
2	CHECK G SENSOR. Turn ignition switch to OFF. Remove G sensor from vehicle. Connect connector to G sensor. Turn ignition switch to ON. Measure voltage between G sensor connector terminals. Connector & terminal:(R70) No. 2 (+) No. 3 (-)	Is the voltage 2.3+/-0.2 V when G sensor is horizontal?	Go to step 3.	Replace G sensor.
3	CHECK G SENSOR. Measure voltage between G sensor connector terminals. Connector & terminal: (R70) No. 2 (+) No. 3 (-)	Is the voltage 3.9+/-0.2 V when G sensor is inclined forwards to 90°?	Go to step 4.	Replace G sensor.
4	CHECK G SENSOR. Measure voltage between G sensor connector terminals. Connector & terminal: (R70) No. 2 (+) No. 3 (-)	Is the voltage 0.7+/-0.2 V when G sensor is inclined backwards to 90°?	G sensor is normal.	Replace G sensor.
5	CHECK G SENSOR. Turn ignition switch to OFF. Connect select monitor connector to data link connector. Turn select monitor into {BRAKE CONTROL} mode. Set the display in the {Current Data Display & Save} mode. Read the G sensor output voltage.	Is the indicated reading 2.3+/-0.2 V when the vehicle is in horizontal position?	Go to step 6.	Replace G sensor.
6	CHECK G SENSOR. Remove console box. Remove G sensor from vehicle. (Do not disconnect connector.) Read the select monitor display.	Is the indicated reading 3.9+/-0.2 V when G sensor is inclined forwards to 90°?	Go to step 7.	Replace G sensor.
7	CHECK G SENSOR. Read the select monitor display.	Is the indicated reading 0.7+/-0.2 V when G sensor is inclined backwards to 90°?	G sensor is normal.	Replace G sensor.