LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2002 >> Forester Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 2.5L >> Self-Diagnostic System >> Verification Procedure >> Subaru Select Monitor (SSM) Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Subaru Select Monitor (SSM) Procedure

  1. After performing diagnosis and clearing ECM memory, warm engine to normal operating temperature. Prepare Subaru Select Monitor by inserting appropriate diagnostic cartridge and connecting diagnostic cable.
  2. Turn ignition off. Locate and connect Green test connector leads together. See Figure, Figure and Figure . Raise and suitably support vehicle, or place all wheels on rollers. Ensure vehicle is properly secured using front and rear towing/tie-down hooks.
  3. Turn ignition off. Connect SSM to 16-pin Data Link Connector (DLC) located under left side of instrument panel. See Figure, Figure and Figure . Turn ignition and SSM on.
  4. On main menu display screen, select {2. Each System Check} and press [YES] key. On <System Selection Menu> display screen, select {Engine Control System} and press [YES] key. After engine type information is displayed, press [YES] key. On <Engine Diagnosis> display screen, select {Dealer Check Mode Procedure} and press [YES] key. When "Perform Inspection (Dealer Check) Mode?" is shown on display screen, press [YES] key. Follow all instructions on display screen.
  5. If problems are still present, DTCs will be displayed. Record codes as required. After codes have been displayed, release parking brake. This verification procedure may cause ABS warning light to illuminate due to speed variations between front and rear wheels. Clear ABS memory. See appropriate ANTI-LOCK article in BRAKES.
scientia non olet · About LEMON Manuals