Assembly
- Install fuel pipe assembly and pressure regulator, etc. to intake manifold.
- Tighten bolt which installs fuel pipes on intake manifold.
Tightening torque: 5.0 N.m (0.51 kgf-m, 3.7 ft-lb)
- Connect right side fuel hose to injector pipe, and tighten clamp screw.
- Install fuel injector pipe.
- Connect left side fuel hose to injector pipe, and tighten clamp screw.
- Connect air assist hoses.
- Install fuel injectors.NOTE: Always use new O-rings.NOTE: Do not forget to install the fuel injector securing clip.
- Tighten bolt which installs injector pipe on intake manifold.
Tightening torque: 5.0 N.m (0.51 kgf-m, 3.7 ft-lb)
- Tighten two bolts which install fuel pipes on the left side of intake manifold.
Tightening torque: 5.0 N.m (0.51 kgf-m, 3.7 ft-lb)
- Tighten bolt which installs injector pipe on intake manifold.
Tightening torque: 5.0 N.m (0.51 kgf-m, 3.7 ft-lb)
- Install purge control solenoid valve.
Tightening torque: 16 N.m (1.6 kgf-m, 12 ft-lb)
- Connect hoses to purge control solenoid valve.CAUTION: Carefully connect the evaporation hoses.
- Install engine harness onto intake manifold.
- Connect connectors to fuel injectors and purge control solenoid valve.
- Hold engine harness by harness band (*).
- Connect pressure regulator vacuum hose to intake manifold.
- Install air assist injector solenoid valve to bracket.
Tightening torque: 5.0 N.m (0.51 kgf-m, 3.7 ft-lb)
- Connect air by-pass hoses to air assist solenoid valve.
- Connect connector to air assist solenoid valve.
- Install throttle body to intake manifold.NOTE: Replace gasket with a new one.
Tightening torque: 22 N.m (2.2 kgf-m, 15.9 ft-lb)
- Connect connector to throttle position sensor and idle air control solenoid valve.
- Connect air by-pass hose to throttle body.
- Install intake air temperature and pressure sensor.
Tightening torque: 3.4 N-m (0.35 kgf-m, 2.5 ft-lb)
NOTE: Replace O-ring with a new one. - Connect connector to intake air temperature and pressure sensor.
- Install ignition coil and ignitor assembly.
- Connect connector to ignition coil and ignitor assembly.
- Install engine ground terminal to intake manifold.
Tightening torque: 19 N.m (1.9 kgf-m, 13.7 ft-lb)