LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2004 >> Forester XT, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Sequence Control With SUBARU Select Monitor

NOTE:
  • In the event of any trouble, the sequence control may not be operative. In such a case, activate the sequence control, referring to "ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR". < Ref. to ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR  .>
  • When the diagnosis terminal is connected to the diagnosis connector, the sequence control will not operate.
  1. Connect the SUBARU Select Monitor to data link connector under driver's seat instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Turn the SUBARU Select Monitor switch to ON.
  4. Put the SUBARU Select Monitor to "BRAKE CONTROL" mode.
  5. When "Function check sequence" is selected, `ABS sequence control' will start.
  6. When the message "Press Brake Pedal with braking force of 100 to 150 kgf" is displayed, perform the following.
    1. When using the brake tester, depress the brake pedal with braking force of 981 N (100 kgf, 221 lb).
    2. When using the pressure gauge, depress the brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2 , 498 psi).
    CAUTION: Do not depress the clutch pedal in case of model with hill holder.
  7. When the message "Press YES" is displayed, press the YES key.
  8. The braking system in operation is displayed on SUBARU Select Monitor.
scientia non olet · About LEMON Manuals