LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2004 >> Forester XT, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A/T Control Systems >> Select Cable >> Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Adjustment

  1. Set the vehicle on a lift.
  2. Set the select lever to "N" range.
  3. Lift-up the vehicle.
  4. Remove the rear exhaust pipe and muffler.
  5. Remove the heat shield cover. (If equipped)
  6. Loosen the adjusting nut on each side.
    Fig 1: Loosening Adjusting Nut
    G00937568Courtesy of SUBARU OF AMERICA, INC.
  7. Turn the adjusting nut B until it lightly touches the connector.
    Fig 2: Turning Adjusting Nut B Until It Lightly Touches Connector
    G00937569Courtesy of SUBARU OF AMERICA, INC.
  8. While preventing the adjusting nut B from moving with a wrench, tighten the adjusting nut A.
    1. Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 
    Fig 3: Tightening Adjusting Nut A
    G00937570Courtesy of SUBARU OF AMERICA, INC.
  9. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
  10. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals