LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Speed Control Systems (H4SO) >> Accelerator Control Cable >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accelerator Control Cable: Installation

  1. Install in the reverse order of removal.
  2. Apply grease to the point (accelerator cable end on engine side) shown in the figure below.

    Part No. 004404002 (Slico lube G-30M)

    Fig 1: Applying Grease To Cable
    G03748726Courtesy of SUBARU OF AMERICA, INC.
    CAUTION:
    • If cable clamp is damaged, replace it with a new one.
    • Never fail to cover outer cable end with boot.
    • Be careful not to kink accelerator cable.
    • Do not apply grease except for special area.
  3. Adjustment after pedal installation < Ref. to , INSTALLATION , Accelerator Pedal. >
scientia non olet · About LEMON Manuals