General Diagnostic Table: Inspection
TROUBLESHOOTING SYMPTOM
| Symptom | Possible cause | Corrective action |
|---|---|---|
| Select lever | Starter does not run. | Adjust the select cable and inhibitor switch, or inspect circuit. |
| Back-up light does not illuminate. | Adjust the select cable and inhibitor switch, or inspect circuit. | |
| AT shift lock control system does not operate normally. | Adjust the select cable and inhibitor switch, or inspect circuit. | |
| Manual mode is not engaged. | Adjust the mode switch and select lever, or inspect circuit. | |
| Up-shift is not engaged at manual mode. | Check the shift-up switch and circuit. | |
| Down-shift is not engaged at manual mode. | Check the shift-down switch and circuit. |