Intake Manifold: Assembly

Liquid gasket: THREE BOND 1105 (Part No.004403010) 

1. Tighten the bolts which install fuel pipes on intake manifold.

   Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb) 

   Fig 1: Locating Fuel Pipes Bolts On Intake Manifold (1 Of 2)

   
   Fig 2: Locating Fuel Pipes Bolts On Intake Manifold (2 Of 2)

   
2. Connect the fuel injector pipe to fuel hose, and tighten the clamp screw.

   Tightening torque: 1.5 N.m (0.15 kgf-m, 1.1 ft-lb) 

   Fig 3: Locating Clamp Screw

   
3. Install the purge control solenoid valve. < Ref. to INSTALLATION , Purge Control Solenoid Valve. >
4. Install the manifold absolute pressure sensor. < Ref. to INSTALLATION , Manifold Absolute Pressure Sensor. >
5. Connect the pressure regulator vacuum hose to the intake manifold.
   Fig 4: Locating Pressure Regulator Vacuum Hose

   
6. Install the throttle body to intake manifold. < Ref. to INSTALLATION , Throttle Body. >
7. Install the engine harness onto intake manifold.