Control Valve Body: Installation

Check the control valve body for dust and other foreign matter.
Install the control valve body to transmission by equally tightening the bolts.
Tightening torque:

8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Identifying Control Valve Body To Transmission With Bolts
Connect the control valve connector.

Fig 2: Identifying Control Valve Connector
Attach the magnet at the specified position of the oil pan.

Fig 3: Identifying Magnet
Apply liquid gasket to the oil pan.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

Fig 4: Identifying Oil Pan Gasket Area
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Pour ATF through the oil charge pipe.
Specified and recommended fluid:

< Ref. to SPECIFICATION , General Description. >

Capacity:

Fill with the same amount of ATF as drained.
Check the ATF level.
< Ref. to AUTOMATIC TRANSMISSION FLUID . >
Perform Clear Memory 2 operation. < Ref. to CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor. >
Perform the inspection with driving the vehicle at the end of repair work, and make sure there is no faulty as below;
- Excessive shift shock
- Oil leakage from the transmission body, etc.
- Occurrence of noise caused by interference etc.
NOTE: If excessive shift shock is felt, execute advance operation of learning control. < Ref. to PROCEDURE , Learning Control. >