MT Gear Shift Lever: Installation

Install the joint to the transmission and secure with a spring pin.
Insert the gear shift lever from the room side.
NOTE: Insert the rod and the stay, and then temporarily set them onto the transmission mount.

Fig 1: Installing Joint To Transmission
Lift up the vehicle.
Mount the cushion rubber on the vehicle body.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 2: Identifying Cushion Rubber And Stay
Using new self-locking nuts, connect the rod to the joint.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 3: Identifying Self-Locking Nuts
Using new self-locking nuts, connect the stay to the transmission bracket.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 4: Identifying Self-Locking Nuts
Install the heat shield cover.

Fig 5: Identifying Heat Shield Cover
Install the rear exhaust pipe and muffler.
- SOHC model
  < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- DOHC turbo model
  < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- DOHC 3.0 L model
  < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
Install the plate assembly to the vehicle body.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
1. Set the plate assembly to the vehicle.
2. Temporarily tighten the bolt (A).
3. Tighten the bolt (B).
4. Tighten the bolt (A).
5. Tighten the bolts (C) and (D).
  
  Fig 6: Identifying Bolts
Install the harness clamp to the plate.
Install the boot and insulator assembly, and secure with a clamp.

Fig 7: Identifying Boot And Insulator Assembly
Install the console box. < Ref. to INSTALLATION , Console Box. >