Select Cable: Installation

Install the select cable to plate assembly.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Select Cable
Install the select cable to range select lever.
Install the plate assembly to transmission.
Tightening torque: T:24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- 4AT
  
  Fig 2: Identifying Plate Assembly
- 5AT
  
  Fig 3: Identifying Plate Assembly
Install the washer and snap pin to range select lever.
- 4AT
  
  Fig 4: Identifying Washer And Snap Pin
- 5AT
  
  Fig 5: Identifying Washer And Snap Pin
Install new clamp paying attention to the installing direction.

Fig 6: Identifying Clamp
Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.

Fig 7: Inserting Tip Of Inner Cable Into Connector Hole Of Select Lever
Shift the select lever to the "N" range, and then adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable. >
Install the heat shield cover.

Fig 8: Identifying Heat Shield Cover
Install the front, center and rear exhaust pipes, and the muffler. (SOHC and DOHC non-turbo model)
- SOHC model
  < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Center Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- DOHC 3.0 L model
  < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
Install the center, rear exhaust pipes and the muffler. (DOHC turbo model)
< Ref. to INSTALLATION , Center Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >