Select Cable: Removal

Set the vehicle on a lift.
Shift the select lever to "N" range.
Disconnect the ground cable from battery.
Lift up the vehicle.
Remove the front, center and rear exhaust pipes and the muffler. (SOHC and DOHC non-turbo model)
- SOHC model
  < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- DOHC 3.0 L model
  < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
Remove the center and rear exhaust pipes and the muffler. (DOHC turbo model)
< Ref. to REMOVAL , Center Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
Remove the heat shield cover.

Fig 1: Identifying Heat Shield Cover
Remove the snap pin and washer from range select lever.
- 4AT
  
  Fig 2: Identifying Snap Pin And Washer
- 5AT
  
  Fig 3: Identifying Snap Pin And Washer
Remove the plate assembly from the transmission case.
- 4AT
  
  Fig 4: Identifying Plate Assembly
- 5AT
  
  Fig 5: Identifying Plate Assembly
Disconnect the cable from arm assembly.

Fig 6: Identifying Cable
Raise the pawl of clamp to remove the cable from bracket.

Fig 7: Locating Pawl Of Clamp
Remove the select cable from plate assembly.