Select Cable: Adjustment

Shift the select lever to "N" range.
Remove the rear exhaust pipe and muffler.
- SOHC model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- DOHC turbo model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- DOHC 3.0 L model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
Remove the heat shield cover.

Fig 1: Identifying Heat Shield Cover
Loosen the adjusting nuts on both sides.

Fig 2: Locating Adjusting Nuts
With the select lever pushed towards the rear of the vehicle, turn the adjustment nut B until it just contacts the connector. Then loosen the nut for 1/2 turn.

Fig 3: Identifying Adjusting Nut Position
Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 4: Identifying Adjusting Nut Position
After the completion of adjustment, confirm that the select lever operates normally at all ranges.
Install in the reverse order of removal.