Select Lever: Removal

Set the vehicle on a lift.
Disconnect the ground cable from battery.
Shift the select lever to "N" range.
Lift up the vehicle.
Remove the rear exhaust pipe and muffler.
- SOHC model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- DOHC turbo model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
- DOHC 3.0 L model
  < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >
Remove the heat shield cover.

Fig 1: Identifying Heat Shield Cover
Remove the cable from arm assembly.

Fig 2: Identifying Cable
Raise the pawl of clamp to remove the cable.

Fig 3: Identifying Pawl Of Clamp
Lower the vehicle.
Remove the console box. < Ref. to REMOVAL , Console Box. >
Remove the center console. < Ref. to REMOVAL , Center Console. >
Remove the harness clips from the bracket.

Fig 4: Identifying Harness Clips
Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.

Fig 5: Locating Select Lever Assembly Bolts