B: Installation
Install in the reverse order of removal.
NOTE:
- Use a new gasket.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the following figure.
- Align protrusion (B) of the fuel sub level sensor to the cut out in the fuel sublevel sensor upper plate.
- Tighten the bolts in the sequence shown in the figure, to the specified torque.
Tightening torque:
4.4 N.m (0.45 kgf-m, 3.2 ft-lb)