Fuel Filler Pipe: Installation

Open the fuel filler flap lid.
Set the fuel saucer (A) with rubber packing (C), and insert the fuel filler pipe into hole from the inner side of apron.
Align the holes in fuel filler pipe neck and set the cup (B), and tighten the nuts.
NOTE: If the edges of rubber packing are folded toward inside, straighten it with a flat tip screwdriver.

Fig 1: Identifying Holes In Fuel Filler Pipe Neck And Set Cup
Courtesy of SUBARU OF AMERICA, INC.
Correctly insert the fuel filler hose to specified position, and then tighten the clamp.

Fig 2: Identifying Fuel Filler Hose
Courtesy of SUBARU OF AMERICA, INC.
Tighten the bolts which hold fuel filler pipe bracket on the body.
Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
Install the rear suspension assembly. <Ref. to INSTALLATION , Installation, Rear Sub Frame .>

Fig 3: Identifying Filler Pipe Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the mud guard. <Ref. to INSTALLATION , Mud Guard .>
Lower the vehicle.
Install the rear wheel RH.
Tightening torque: Chrome plated wheel 150 N.m (15.3 kgf-m, 110.6 ft-lb)

Other than above 120 N.m (12.2 kgf-m, 88.5 ft-lb)
Connect the battery ground cable to the battery.