Intake Manifold: Assembly

Liquid gasket: THREE BOND 1105 (Part No. 004403010) 

Tightening torque: 17 N.m (1.7 kgf-m, 12.5 ft-lb) 

1. Tighten the bolts which install fuel pipes on intake manifold.

   Tightening torque: 6.4 N.m (0.65 kgf-m, 4.7 ft-lb) 

   Fig 1: Identifying Fuel Pipes Bolts

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Identifying Intake Manifold Bolts

   Courtesy of SUBARU OF AMERICA, INC.
2. Connect the fuel injector pipe to fuel hose, and tighten the clamp screw.

   Tightening torque: 1.5 N.m (0.15 kgf-m, 1.1 ft-lb) 

   Fig 3: Identifying Fuel Hose

   Courtesy of SUBARU OF AMERICA, INC.
3. Install the purge control solenoid valve. <Ref. to INSTALLATION , Purge Control Solenoid Valve .>
4. Install the manifold absolute pressure sensor. <Ref. to INSTALLATION , Manifold Absolute Pressure Sensor .>
5. Install the throttle body to intake manifold. <Ref. to INSTALLATION , Throttle Body .>
6. Install the engine harness to the intake manifold.