LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> A/T Control Systems >> Select Cable >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

  1. Set the vehicle on a lift.
  2. Shift the select lever to "N" range.
  3. Disconnect the ground cable from battery.
  4. Lift-up the vehicle.
  5. Remove the front, center and rear exhaust pipes and muffler. < Refer to REMOVAL , Front Exhaust Pipe. > < Refer to REMOVAL , Rear Exhaust Pipe. > < Refer to REMOVAL , Muffler. >
  6. Remove the heat shield cover.
  7. Remove the snap pin and washer from range select lever.
    Fig 1: Identifying Snap Pin, Washer And Range Select Lever
    G05031937Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from the transmission case.
    Fig 2: Identifying Plate Assembly And Select Cable
    G05031938Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from arm assembly.
    Fig 3: Identifying Adjusting Nut And Arm Assembly
    G05031939Courtesy of SUBARU OF AMERICA, INC.
  10. Raise the pawl of clamp to remove the cable from bracket.
    Fig 4: Identifying Cable Clamp
    G05031940Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
scientia non olet · About LEMON Manuals