LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> A/T Control Systems >> Select Lever >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Lever: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Shift the select lever to "N" range.
  4. Lift-up the vehicle.
  5. Remove the rear exhaust pipe and muffler. < Refer to REMOVAL , Rear Exhaust Pipe. > < Refer to REMOVAL , Muffler. >
  6. Remove the heat shield cover.
  7. Remove the cable from arm assembly.
    Fig 1: Identifying Adjusting Nut And Arm Assembly
    G05031896Courtesy of SUBARU OF AMERICA, INC.
  8. Raise the pawl of clamp to remove the cable.
    Fig 2: Identifying Cable Clamp
    G05031897Courtesy of SUBARU OF AMERICA, INC.
  9. Lower the vehicle.
  10. Remove the console box. < Refer to REMOVAL , Console Box. >
  11. Remove the center console. < Refer to REMOVAL , Center Console. >
  12. Remove all harnesses from the select lever.
    Fig 3: Identifying Select Lever Harnesses
    G05031898Courtesy of SUBARU OF AMERICA, INC.
  13. Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.
    Fig 4: Identifying Select Lever Assembly Bolts
    G05031899Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals