LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> Forester X, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (H4SO) >> Fuel Injector >> Removal >> RH Side
April 5, 2026: LEMON Manuals is launched! Read the announcement.

RH Side

  1. Release the fuel pressure.

    <Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel . >

  2. Disconnect the ground cable from the battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G04988132Courtesy of SUBARU OF AMERICA, INC.
  3. Open the fuel filler flap lid, and remove the fuel filler cap.
  4. Remove the air intake duct and air cleaner case. <Ref. to REMOVAL , Air Intake Duct. > <Ref. to REMOVAL , Air Cleaner Case. >
  5. Remove the power steering pump and power steering reservoir tank.
    1. Remove the front side V-belt. <Ref. to REMOVAL , V-belt. >
    2. Remove the bolts which hold the power steering pipes onto the intake manifold protector RH.
      NOTE: Do not disconnect the power steering hose.
      Fig 2: Identifying Bolts Which Holding Power Steering Pipes Onto Fuel Pipe Protector RH
      G04997327Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolts which install the power steering pump to the bracket.
      Fig 3: Identifying Power Steering Pump Bracket Bolts
      G04997328Courtesy of SUBARU OF AMERICA, INC.
    4. Disconnect the connector from power steering pump switch (A).
      Fig 4: Identifying Power Steering Pump Switch Connector
      G04997329Courtesy of SUBARU OF AMERICA, INC.
    5. Remove the power steering reservoir tank from the bracket by pulling it upward.
      Fig 5: Identifying Power Steering Reservoir Tank Bracket
      G04997330Courtesy of SUBARU OF AMERICA, INC.
    6. Place the power steering pump and tank on the right side wheel apron.
      Fig 6: Placing Power Steering Pump On Right Side Wheel Apron
      G04997331Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spark plug cords from spark plugs (#1 and #3 cylinders).
  7. Remove the fuel pipe protector RH.
    Fig 7: Identifying Fuel Pipe Protector Bolts RH
    G04997361Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the connectors (A) from fuel injector.
  9. Remove the harness band (B) which holds the engine harness to injector pipe.
    Fig 8: Identifying Fuel Injector Connectors And Engine Harness Band
    G04997406Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the bolt which holds fuel injector pipe onto intake manifold.
    Fig 9: Identifying Injector Pipe Bolts (RH Side)
    G04997365Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the fuel injector while lifting up the fuel injector pipe.