Fuel Filler Pipe: Installation

Open the fuel filler flap lid.
Set the fuel saucer (A) with rubber seal (C), and insert the fuel filler pipe into hole from the inner side of apron.
Align the holes in fuel filler pipe neck and set the cup (B), and tighten the screws.
NOTE: If the edges of rubber seal are folded toward inside, straighten it with a flat tip screwdriver.

Fig 1: Identifying Fuel Saucer And Rubber Seal
Courtesy of SUBARU OF AMERICA, INC.
Securely insert the fuel filler hose (A) and evaporation hose (B) to the specified position, then tighten the clamp.

Fig 2: Identifying Fuel Filler Hose And Evaporation Hose
Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Identifying Evaporation Hose
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Identifying Insertion Position Of Pipe And Hose
Courtesy of SUBARU OF AMERICA, INC.
Tighten the bolts which hold fuel filler pipe bracket on the body.
Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 5: Locating Fuel Filler Pipe Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the rear sub frame. <Ref. to INSTALLATION , Rear Sub Frame .>
Install the mud guard. <Ref. to INSTALLATION , Mud Guard .>
Lower the vehicle.
Install the rear wheel RH.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)
Connect the battery ground cable to the battery.

Fig 6: Connecting Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.