Fuel Sub Level Sensor: Installation

Install in the reverse order of removal.

NOTE:

Use a new gasket.
Make sure the sealing portion is free from fuel or foreign matter before installation.
Align protrusion (A) of the gasket to the position shown in the following figure.
Align protrusion (B) of the fuel sub level sensor to the cut out in the fuel sublevel sensor upper plate.
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

Tightening torque: 4.4 N.m (0.45 kgf-m, 3.2 ft-lb)

Fig 1: Identifying Nuts Tightening Sequence

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating Fuel Sub Level Sensor Bolts

Courtesy of SUBARU OF AMERICA, INC.