Injector Control (Injection Quantity Control)
CAUTION:
After performing the Operation Check Mode, perform the Clear Memory Mode <Ref. to
OPERATION , Clear Memory Mode .>.
- On the «System Operation Check Mode» display screen, select {Injector Control}.
- On the «Injector Control» display screen, select {Injection Quantity Control}.
- On the «Start the Engine» display screen, start the engine and select the [OK].
- In the «Injection Quantity Control» screen, select the [↑] or the [↓] to change the setting values, then select the [OK].
Setting is possible in a range between 0 - 20%, in increments of 1%.
- Select the [NO] to end the injection quantity control. The screen will return to the «Injector Control» screen.NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".