LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> Outback i, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A/T Control Systems >> Select Cable >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Installation

  1. Install the select cable to plate assembly.

    Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 1: Identifying Select Cable Bolt Tightening Torque
    G05019691Courtesy of SUBARU OF AMERICA, INC.
  2. Install the select cable to range select lever.
  3. Install the plate assembly to transmission.

    Tightening torque: T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb) 

    • 4AT
      Fig 2: Identifying Plate Assembly Bolt Tightening Torque - 4AT
      G05341826Courtesy of SUBARU OF AMERICA, INC.
    • 5AT
      Fig 3: Identifying Plate Assembly Bolt Tightening Torque - 5AT
      G05341827Courtesy of SUBARU OF AMERICA, INC.
  4. Install the washer and snap pin to range select lever.
    • 4AT
      Fig 4: Identifying Range Select Lever Washer And Snap Pin - 4AT
      G05341828Courtesy of SUBARU OF AMERICA, INC.
    • 5AT
      Fig 5: Identifying Range Select Lever Washer And Snap Pin - 5AT
      G05341829Courtesy of SUBARU OF AMERICA, INC.
  5. Install new clamp paying attention to the installing direction.
    Fig 6: Installing Clamp Paying Attention To Installing Direction
    G05341830Courtesy of SUBARU OF AMERICA, INC.
  6. Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
    Fig 7: Inserting Tip Of Inner Cable Into Connector Hole Of Select Lever
    G05019697Courtesy of SUBARU OF AMERICA, INC.
  7. Shift the select lever to the "N" range, and then adjust the select cable position. <Ref. to ADJUSTMENT  , Select Cable .>
  8. Install the heat shield cover.
    Fig 8: Identifying Heat Shield Cover
    G05019661Courtesy of SUBARU OF AMERICA, INC.
  9. Install the front, center and rear exhaust pipes, and the muffler. (SOHC and DOHC non-turbo model)
  10. Install the center, rear exhaust pipes and the muffler. (DOHC turbo model) <Ref. to INSTALLATION , Center Exhaust Pipe .> <Ref. to INSTALLATION , Rear Exhaust Pipe .> <Ref. to INSTALLATION , INSTALLATION, Muffler .>