5MT Model

Install in the reverse order of removal.
NOTE: Before installing the operating cylinder, apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.

Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)

NOTE: The illustration below is for a Non-turbo model. However, perform the same procedures for the Turbo model.

Fig 1: Installing Operating Cylinder
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that the clutch operates properly.
<Ref. to CLUTCH FLUID AIR BLEEDING . >