Fuel Sub Level Sensor: Removal

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:

Be careful not to spill fuel.
When the fuel meter indication is higher than two third of the total, perform the work after draining the fuel not to spill the fuel.

Drain fuel. < Ref. to DRAINING FUEL (WITH SUBARU SELECT MONITOR) , PROCEDURE, Fuel. >
Remove the rear seat.
Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.
  
  Fig 1: Identifying Service Hole Cover Grommet And Bolt
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the fuel sub level sensor.

Fig 2: Identifying Fuel Sub Level Sensor
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the quick connector, and then disconnect the fuel delivery hose and jet pump hose. < Ref. to REMOVAL , Fuel Delivery and Evaporation Lines. >
Remove the nuts and bolts which install fuel sub level sensor on fuel tank.

Fig 3: Identifying Jet Pump Hose And Delivery Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel sub level sensor.