LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Diagnostic Trouble Code (DTC) Detecting Criteria (H4SO) >> Diagnostic Trouble Code (DTC) Detecting Criteria >> DTC P1602 Control Module Programming Error >> Enable Condition
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Enable Condition

ENABLE CONDITION

Secondary Parameters Enable Conditions
Barometric pressure > 75.1 kPa (563 mmHg, 22.2 inHg)
Battery voltage > 10.9 V
Cold start diagnosis Incomplete
Engine Starting
Vehicle speed ≤ 2 km/h (1 MPH)
Misfire within 200 engine revs. < 5
Time after starting = 14 seconds


ENABLE CONDITION

Secondary Parameters Enable Conditions
Barometric pressure > 75.1 kPa (563 mmHg, 22.2 inHg)
Battery voltage > 10.9 V
Cold start diagnosis Incomplete
Engine Starting
Vehicle speed ≤ 3 km/h (2 MPH)
After ISC control ≥ 1.5 seconds
Lower limit number of revolutions counter < 2000
Nuetral switch ON/OFF operation > 3 seconds
Catalyst advanced idling retard angle control 1 Controlled
Catalyst warm up Under catalyst warm up
After load (A/C, power steering, lighting, rear defogger, heater fan and radiator fan) operations ≥ 3.5 seconds
Misfire within 200 engine revs. < 5
Cold start (with the following conditions established)  
|Engine coolant temperature - intake air temperature| ≤ 5°C(41°F)
|Engine coolant temperature - Fuel temperature| ≤ 2°C (36°F)
Warm up mode shift time ≥ 6 seconds
ENABLE CONDITION

Secondary Parameters Enable Conditions
Barometric pressure > 75.1 kPa (563 mmHg, 22.2 inHg)
Battery voltage > 10.9 V
Cold start diagnosis Incomplete
Engine Starting
Vehicle speed ≤ 3 km/h (2 MPH)
After ISC control ≥ 1.5 seconds
Lower limit number of revolutions counter < 2000
Nuetral switch ON/OFF operation > 3 seconds
Catalyst advanced idling retard angle control 1 Controlled
Catalyst warm up Under catalyst warm up
After load (A/C, power steering, lighting, rear defogger, heater fan and radiator fan) operations ≥ 3.5 seconds
Misfire within 200 engine revs. < 5
Intake air amount diagnosis Undetermined
Cold start (with the following conditions established)  
|Engine coolant temperature - intake air temperature| ≤ 5°C(41°F)
|Engine coolant temperature - Fuel temperature| ≤ 2°C (36°F)
Warm up mode shift time ≥ 6 seconds