LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (H4SO) >> Fuel Filler Pipe >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Filler Pipe: Removal

WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION: Be careful not to spill fuel.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from the battery.
    Fig 1: Identifying Ground Cable From Battery
    G05019586Courtesy of SUBARU OF AMERICA, INC.
  3. Open the fuel filler flap lid, and remove the filler cap.
  4. Remove the screws which secure gasket.
    Fig 2: Locating Filler Cap Screws
    G04997449Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the rear wheel RH.
  6. Lift up the vehicle.
  7. Drain fuel from fuel tank. <Ref. to DRAINING FUEL , PROCEDURE, Fuel .>
  8. Remove the mud guard. <Ref. to REMOVAL , Mud Guard .>
  9. Remove the rear sub frame. <Ref. to REMOVAL , Rear Sub Frame .>
  10. Remove the bolts which hold fuel filler pipe bracket on the body.
    Fig 3: Locating Fuel Filler Pipe Bracket Bolts
    G05016904Courtesy of SUBARU OF AMERICA, INC.
  11. Loosen the clamp, and disconnect the fuel filler hose (A) and evaporation hose (B).
    Fig 4: Identifying Fuel Filler Hose And Evaporation Hose
    G05016905Courtesy of SUBARU OF AMERICA, INC.
    Fig 5: Identifying Evaporation Hose
    G05016906Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the fuel filler pipe to the underside of the vehicle.