Fuel Pump: Installation
Install in the reverse order of removal.
NOTE:
- Use a new gasket.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- When assembling, point the protrusion of the gasket (A) towards the front of the vehicle.
- Insert the protrusion (B) of the gasket into the upper plate. (3 locations)
- Align the protrusion (C) of the fuel pump assembly to the cut out in the upper plate.
- Tighten the nuts to the specified torque in the order as shown in the figure.
Tightening torque: 4.4 N.m (0.45 kgf-m, 3.2 ft-lb)