LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Subaru Select Monitor >> Operation >> How To Use The SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How To Use The SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description .>
  2. Connect the diagnosis cable to the Subaru Select Monitor.
  3. Connect the Subaru Select Monitor to the data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 1: Locating Data Link Connector
      G05339835Courtesy of SUBARU OF AMERICA, INC.
    2. Connect the diagnosis cable to the data link connector.
      CAUTION: Do not connect the scan tools except for the Subaru Select Monitor or general scan tool.
  4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
  5. Using the Subaru Select Monitor, call up DTC and data, then record them.
scientia non olet · About LEMON Manuals