14 FLASHWRITE Error Code 4404 (SUSTIPS 0811-01)
Publication date: 2011-08-01Reference number: SUSTIPS 0811-01
14 FLASHWRITE ERROR CODE 4404
TECHNICAL INFORMATION TIP
Reference Number(s): SUSTIPS 0811-01, Date of Issue:
August 1, 2011
| SUBARU: | 2006-2010 Forester, Impreza, Legacy, Outback |
SERVICE INFORMATION
If you encounter an Error Code 4404 "Failed to change session mode. Reprogramming is aborted." while performing Service Program Bulletin WVU-31, try using the following procedure:
- Exit all open programs on the Subaru Select Monitor III.
- Disconnect the "D" check connectors.
- Turn the ignition key to the "Off" position then back to the "On" position.
- Shift the transmission select lever from Park into Neutral then back into the Park position.
- Open Flash Write and select the correct PAK file to be installed. Proceed with reprogramming.
- If the same error code occurs again, repeat the above procedure but do not disconnect the "D" check connectors.
As always, remember to have the Subaru Select Monitor III plugged into a 120 volt AC power supply and ensure that you have good connections to the data link connector, SDI box and supporting USB cable.