Select Cable: Installation

Install the select cable to plate assembly.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Plate Assembly Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the select cable to range select lever.
Install the plate assembly to transmission.
Tightening torque:

T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- 4AT
  
  Fig 2: Identifying Select Cable And Plate Assembly (4AT)
  Courtesy of SUBARU OF AMERICA, INC.
- 5AT
  
  Fig 3: Identifying Select Cable And Plate Assembly (5AT)
  Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to range select lever.
- 4AT
  
  Fig 4: Identifying Washer, Snap Pin And Range Select Lever (4AT)
  Courtesy of SUBARU OF AMERICA, INC.
- 5AT
  
  Fig 5: Identifying Washer, Snap Pin And Range Select Lever (5AT)
  Courtesy of SUBARU OF AMERICA, INC.
Install new clamp paying attention to the installing direction.

Fig 6: Identifying Clamp
Courtesy of SUBARU OF AMERICA, INC.
Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.

Fig 7: Identifying Tip Of Inner Cable Into Connector Hole
Courtesy of SUBARU OF AMERICA, INC.
Shift the select lever to the "N" range, and then adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable . >
Install the heat shield cover.

Fig 8: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the front, center and rear exhaust pipes, and the muffler. (SOHC and DOHC non-turbo model)
- SOHC MODEL
  < Refer to INSTALLATION , Front Exhaust Pipe. >, < Refer to INSTALLATION , Rear Exhaust Pipe. > & < Refer to INSTALLATION , Muffler. >
- DOHC 3.0 L model
  < Ref. to INSTALLATION , Front Exhaust Pipe . > < Ref. to INSTALLATION , Rear Exhaust Pipe . > < Ref. to INSTALLATION , Muffler . >
Install the center, rear exhaust pipes and the muffler. (DOHC turbo model)
< Refer to INSTALLATION , Center Exhaust Pipe. > < Refer to INSTALLATION , Rear Exhaust Pipe. > < Refer to INSTALLATION , Muffler. >