Fuel Sub Level Sensor: Removal

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:

Be careful not to spill fuel.
Prior to start work, be sure to set the fuel volume to three-forth full of the fuel tank. If the fuel is more than three-forth full of the fuel tank, be careful because the fuel may spill out.

Set the vehicle on a lift.
Disconnect the ground cable from the battery.

Fig 1: Identifying Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Drain fuel. <Ref. to DRAINING FUEL , PROCEDURE, Fuel .>
Remove the rear seat.
Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.
  
  Fig 2: Identifying Grommet And Bolts
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the fuel sub level sensor.

Fig 3: Identifying Fuel Sub Level Sensor
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the quick connector, then disconnect the fuel delivery hose and jet pump hose. <Ref. to REMOVAL , Fuel Delivery and Evaporation Lines .>
Remove the nuts and bolts which install fuel sub level sensor on fuel tank.

Fig 4: Identifying Fuel Delivery Hose And Jet Pump Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel sub level sensor.