Knock Sensor: Installation

Install the knock sensor to cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque: 24 N.m (2.4 kgf-m, 17.4 ft-lb)

Fig 1: Identifying Knock Sensor Installation Position
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake chamber.
<Ref. to INSTALLATION , Air Intake Chambers .>
Connect the battery ground cable to battery.

Fig 3: Identifying Battery Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.