AT Shift Lock Solenoid and "P" Range Switch: Installation

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:

Refer to "COMPONENT " for each tightening torque. <Ref. to COMPONENT , General Description. >
Set the select lever to "D" range (normal mode position) when installing the guide plate and be careful of the following.

Insert protrusion (B) of the guide plate into the hole on the shift lock solenoid unit (A).
Insert link (D) of the shift lock release into link (C) of the shift lock solenoid unit.

Fig 1: Locating Shift Lock Solenoid Unit
Courtesy of SUBARU OF AMERICA, INC.
Connect the switch and solenoid terminals to the connector.

Fig 2: Identifying Switch And Solenoid Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.