Tilt Steering Column: Installation
- Install the grommet to the toe board.
- Insert the end of the steering shaft into the toe board grommet.
- With the tilt lever secured, tighten the steering shaft mounting bolts under instrument panel.
Tightening torque: 25 N.m (2.5 kgf-m, 18.1 ft-lb)
- Connect all the connectors under the instrument panel.
- Connect the airbag system connector at the harness spool.NOTE: Make sure to apply double lock.
- Install the instrument panel lower cover with tilt lever held in the lowered position.
- Install the universal joint. <Ref. to INSTALLATION , Universal Joint.>
- Align the center position of the roll connector. <Ref. to ADJUSTMENT , Roll Connector.>
- Install the steering wheel. <Ref. to
INSTALLATION , Steering Wheel.>CAUTION: Insert the roll connector guide pin into the guide hole on lower end of steering wheel surface to prevent damage.