Rear Door Glass: Removal

Remove the rear door trim. < Ref. to REMOVAL , Door Trim.>
Remove the sealing cover. < Ref. to REMOVAL , Rear Sealing Cover.>
Apply the protective tape (1) to the areas as shown in the figure.

Fig 1: Identifying Rear Door Glass Protective Tape Area
Courtesy of SUBARU OF AMERICA, INC.
Operate the power window switch to move the glass to the position shown in the figure, and then remove the two bolts through service holes.

Fig 2: Locating Power Window Switch Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the sash retaining bolts (A), and loosen the retaining nuts (B).

Fig 3: Identifying Retaining Bolts And Retaining Nuts
Courtesy of SUBARU OF AMERICA, INC.
Move the sash (C) upward, and move the nut (B) to the position on rear door as shown in the figure.

Fig 4: Identifying Sash And Nut
Courtesy of SUBARU OF AMERICA, INC.
Detach the rear part of door glass from sash (1), and move it backward (2). Tilt the door glass inward, and move it upward to remove (3).

Fig 5: Identifying Door Glass Sash
Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removing glass.
- Avoid impact and damage to the glass.
Remove the glass run rubber.
Remove the door sash.