Intake Manifold: Assembly

Liquid gasket: 

THREE BOND 1105 (Part No. 004403010) or equivalent 

Tightening torque: 

17 N.m (1.7 kgf-m, 12.5 ft-lb) 

1. Install the EGR valve. <Ref. to INSTALLATION , EGR Valve.>
2. Tighten the bolts which install fuel pipes on intake manifold.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

   Fig 1: Locating Bolts Installing Fuel Pipes On In-Take Manifold (1 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Locating Bolts Installing Fuel Pipes On In-Take Manifold (2 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
3. Connect the fuel injector pipe to fuel hose, and tighten the clamp screw.

   Tightening torque: 

   1.5 N.m (0.2 kgf-m, 1.1 ft-lb) 

   Fig 3: Identifying Fuel Hose

   Courtesy of SUBARU OF AMERICA, INC.
4. Install the purge control solenoid valve. <Ref. to INSTALLATION , Purge Control Solenoid Valve.>
5. Install the manifold absolute pressure sensor. <Ref. to INSTALLATION , Manifold Absolute Pressure Sensor.>
6. Install the throttle body to intake manifold. <Ref. to INSTALLATION , Throttle Body.>
7. Install the engine harness to the intake manifold. <Ref. to ENGINE HARNESS , COMPONENT, General Description.>