Front Stabilizer: Installation

Install in the reverse order of removal.

NOTE:

Use a new flange nut (with WAX).
Install so that the paint mark on the stabilizer is on the left side of the vehicle.
Install the stabilizer bushing (front crossmember side) while aligning it with the paint mark on stabilizer.

Tightening torque:

Stabilizer link:

60 N.m (6.1 kgf-m, 44.3 ft-lb)

Stabilizer clamp:

25 N.m (2.5 kgf-m, 18.1 ft-lb)